Topic: The Best PCP Air Rifle co*pressors of 2023 (Read 29 times)
previous topic - next topic
It's your post, so post it!
The reasons I like this co*pressor are multifaceted; the system runs fairly quietly (which is relative when discussing small co*pressors), the user interface is intuitive and easy to work with, and the fill rate is good. I appreciate the integrated moister filter and additional filters shipped with the unit. But what really appeals to me is that this is one of the only portable co*pressors rated not only for direct filling of guns, but for small carbon fiber tanks as well.
Hatsan specifies that the Volt can be used for filling up to 1-liter tanks (about 61 cubic inches), which is a standard paintball tank. This means that you can charge your gun, fill a small buddy bottle, and be good for a few days of hunting. I think to get the full benefit of this co*pressor, you’ll probably want to add a small carbon fiber tank at some point, though that is certainly not a requirement. I will say that this co*pressor does an excellent job of keeping even the more air hungry and high pressure driven big bore rifles I shoot fully filled and ready for action.
I have been using the Airmarksman portable co*pressor for over two years now, and it has provided a reliable and trouble-free source of air to feed my lineup of hunting rifles from the standard calibers on up to the big bores. While I haven’t done a formal quantitative test, based on my experience, this co*pressor charges the most powerful air rifles faster than any other in my lineup.
The Airmarksman is a co*pact co*pressor running off both AC and DC power sources that are designed to fill an air rifle directly. Connect the rifle, charge it up, and go shooting. This co*pressor also features a simple and easy to use interface for a quick setup. The Airmarksman can fill guns to a maximum pressure of 4500 psi, with an auto shutdown to power down once the desired pressure is reached, which means you don’t have to monitor the gun as it fills.
Read Next: Can Air Rifles Effectively Kill Big Game? In Short, Yes
I use a hybrid approach to keeping my rifles charged on long hunting excursions. I’ll fill a couple tanks from my industrial co*pressor before leaving home to quickly fill guns in the field. But I also carry a portable co*pressor to top off my guns as the external tanks pressure drops, or as insurance in case I run out of air. The Hatsan TactAir Spark is so small and co*pact that it stays permanently stored in the cargo area of my vehicle, always ready when needed. This device has saved more hunts for me than any other device I’ve used, because it can be easily packed away and is always available.
The Hatsan TactAir Spark is a dual power (with an external AC power module) co*pact co*pressor that can be directly connected to a PCP air rifle to quickly charge it up to a pressure of 4500 psi. Measuring in at 5.5 x 5.25 x 6.5 inches, this handy little co*pressor provides big performance in a small package. The interface is easy to use and features an automatic shutoff so guns can be filled without being monitored.
I have been using Omega Supercharger for a few years to fill everything from small buddy bottles up to 100 cubic feet tanks. The Omega has been a reliable workhorse requiring only minimal service and upkeep, which was easy to provide and required no specialized tools and only minimal mechanical skill. More recently the Omega Turbo Charger model was released, which utilizes dual piston technology to reduce the fill time by approximately 50 percent. There is an automatic shut off that is preset using twin indicator arms in an easy-to-read pressure gauge. When the predetermined pressure is reached the co*pressor shuts itself off automatically. A programmable auto bleed setting allows any duration and interval to be set dependent on environmental conditions (e.g. humidity). The co*pressor will bleed off all moisture and shut down when filling is co*plete.
The Turbo Charger design ensures protection of equipment from corrosive moisture as well as very quiet operation. The hour meter tracks active co*pressor usage and alerts the user when routine service is due. The Turbo Charger housing has a carbon fiber finished, all-metal case that protects it from the elements. Included is a carry handle for portability, a tool kit with spare parts and lubricants, a filling hose with a female quick disconnect, and one-year parts and labor warranty.
I don’t think this is a co*pressor for everybody, due to cost, size, and lack of AC power capability, but if you shoot a lot, prefer to carry fully charged tanks into the field, or need to provide air for several shooters, the Omega Turbo Charger co*pressor is a great option.
Xisico is an established manufacturer which has long supplied guns and co*ponents on an OEM basis to the airgunning industry. But at the SHOT Show they were introducing their new US based co*pany, JTS, and its branded products. One that caught my eye was their GX-E-CS3 co*pact co*pressor, which has been on the market under various labels for a while and has garnered a solid user base. I was anxious to give this co*pressor a try and ordered one soon after returning home. This attractively priced and feature rich platform has performed well for me over the last few months, but what really stood out was how quiet this device was. The mechanical noise is low, and there is minimal movement when in operation.
The GTX co*pressor can fill a PCP airgun directly using the included 110V to 12V converter, or directly from a 12V DC source. It will fill most PCP airguns in 5-12 minutes, with an even quicker turn-around on top-offs. This product is not a replacement for larger co*pressors designed to fill large volume tanks being smaller, slower, and not designed to run for more than 15-minute intervals.
The Nomad Portable co*pressor has been the primary workhorse in the Air Venturi line for a few years now and has been my go-to co*pressor in the field. I have covered literally thousands of miles with this co*pressor, charged many rifles ranging from standard caliber small game guns up to my big game/big bore rifles, and it has never failed me, The only downside is the price at almost $700.
Air Venturi has slipped an intermediate co*pressor into the line up with the RovAir 4500 PSI Portable PCP co*pressor. It is a reliable and co*pact co*pressor that offers fill times on par with the Nomad III and up to 25 percent faster than the Nomad II. It has a reduced price but provides the same dependable performance that field shooters need and expect. The fill times achieved by this model are impressive, and almost any high-pressure rifle can be filled in 5-15 minutes depending on onboard reservoir size and specified fill pressures (much quicker for top-offs).
Another much appreciated characteristic is that the RovAir does not require constant maintenance and oil refills as did many earlier co*pressors. The Air Venturi RovAir is an excellent solution for filling PCP guns in the field because it can be used on a 12V automotive battery for portable operation, but then can be plugged into a wall socket when you return home. I believe that when all is considered, the RovAir might be the best all around value in a portable co*pressor today.
Read Next: Best Air Rifles
PCP Air Rifles have integrated air storage, such as a reservoir tube or a bottle at the forestock or butt, which will hold enough air for multiple shots. How many shots depends on several variables: the capacity of the tank, fill pressure, projectiles used, power output of the gun, and efficiency of air flow through the gun to name a few. Typically, standard caliber guns will store enough air for 25 to 150 shots per fill, while big bores generally provide far fewer shots per fill, in the three to ten shot range.
If you find yourself refilling frequently, you might need to power your co*pressor in the field. Some of the co*pressors on this list have flexible power sources and some are built-in, but you can also use portable power stations that have 120v plugs to keep your co*pressor running.
To keep the gun filled to the appropriate volume and pressures, air must be supplied through an external source. There are a few options: hand pumps, tanks, or co*pressors. There are pros and cons to each, and after a quick look at these we’ll take a look at a few of my favorite solutions.
hand pumps used to fill PCP air rifles look like a bicycle tire pump on steroids. They are larger and made of much heavier materials to stand up to the high pressures, but work along the same lines. However, while a bike tire requires a small volume of air at pressures usually well under 130 psi, PCP airguns have a larger air reservoir and need pressures of at least 1500 psi to over 4000 psi. Moving this volume of air to these pressures requires a great deal of effort.
The advantages of hand pumps are that they tend to be the least expensive method, are fully self-contained, and are effective—though not easy. And that’s the major con; these pumps require the user to lay their full body weight into each stroke of the pump, and to do so over a couple hundred pumps. If the individual doing the pumping is of smaller stature, this beco*es very difficult if not impossible. And if they are heavier, I hope it’s muscle because you are in for a workout.
The next option is an air tank, which depending on the pressures you need to fill your gun, could be either an aluminum scuba tank or a high-pressure, carbon fiber tank. These external tanks will hold a large volume of co*pressed air that is then used to refill the gun and will usually provide several refills before it needs to be refilled. The tank is then brought to a facility with a co*pressor such as a dive shop, paintball shop, or sometimes a fire station, to be refilled. This is the method I used for many years. I had three carbon fiber tanks (I do a lot of shooting) that I would bring to the local paintball shop, and they could refill my tanks to 3800 psi and would charge me $5 per tank.
Whether using scuba or carbon fiber tanks, the cons are that tanks are considerably more expensive than a hand pump and have an ongoing cost to refill them. You need to find a place to refill them as well, and many dive shops and to a lesser degree paintball shops, are limited in the pressures they can provide. And lastly, every few years you need to bring your tanks in for testing and certification. However, on the pro side, once you have a place to refill tanks, they are very easy, portable, and fast to use.
The holy grail for most airgunners would be their own co*pressor, which could then be used to fill scuba or carbon fiber tanks whenever required. The paintball shops I was using to fill my tanks had limited hours of operation and a limit on the pressure to which they could fill these tanks. I not only had many guns to fill, but also several that filled to pressures exceeding the limits imposed at these refill stations, so getting a co*pressor was a game change for me. A couple times a month, I could collect all my external tanks and refill them, and then have air on tap whenever it was needed.
The problem was costs. A co*pressor at that time could easily cost $2,000 to $4,000, and since they were large and only ran on an AC power source, still required tanks to recharge in the field. The price has co*e down somewhat on the full-sized co*pressors designed for refilling high pressure large volume carbon fiber tanks. There are now options for quality co*pressors at around $1,300 to $4,000, but you’ll probably still need an external air tank for refills in the field which adds several hundred dollars to the bill. These co*pressors tend to be large, loud, and can be mechanically co*plex to operate and service, though this is also improving with newer models. On the pro side, you have a never-ending supply of air, and over time the costs are averaged down.
More recently another alternative has beco*e available, and that is the co*pact co*pressor designed to fill the smaller air reservoirs on the gun directly, negating the need for an intermediate air tank. These co*pressors are characterized by their small footprint, low weight, ability to run on AC or DC power, and simplicity of operation. Continuing the pros, the costs for these devices tend to be attractive, typically in the $400 to $800 range.
On the con side of the proposition, these co*pressors cannot be used to fill large volume external tanks, they can be loud, and they take longer to refill the gun than when filling from a carbon fiber tank. Probably the biggest advantage is that the co*pact co*pressor frees the airgunner from reliance on a third party to keep their guns running and is probably the most cost-effective approach aside from the hand pump. Considering all of the advantages these devices provide, I believe that for many shooters they provide an ideal solution.
Since 1898, OL has been a leading authority in testing and reviewing hunting gear, fishing tackle, guns and shooting equipment, and much more. We have more than a century-long history of evaluating products, and we’re now bringing that expertise to online reviews. Our editors are experienced outdoorsmen and women, and most importantly, we’re trained journalists. We prioritize field testing and objective data when reviewing products. We conduct interviews with gear manufacturers and engineers as well as outdoor experts so that our readers have an understanding of how and why a product works—or doesn’t.
Advertising does not influence our gear reviews and it never will. While we always focus our coverage on standout products—because we want our readers to be aware of the latest and greatest gear—we also cover the flaws and quirks of any given product.
The method you select to keep your guns filled depends on several factors. I would not reco*mend a hand pump if you do a lot of shooting, unless you really enjoy a workout and need to economize on your equipment budget. Tanks are a very good option if you have a fill station, paintball shop, dive shop, or fire department that is both willing and able to fill tanks for you. Or if you have your own high-volume co*pressor and can fill tanks whenever needed. However, this type of co*pressor can be quite expensive, and you could expect to pay at least $1500, and very possibly much more.
The recent advent of portable co*pressors has provided another option that offers many advantages to the airgunner. While not a solution for filling large volume external tanks, these devices do an excellent job of filling individual guns. It takes longer to fill a gun from a portable co*pressor than an external tank, but it is still fairly quick, and an order of magnitude quicker than a hand pump. I believe that depending on your individual requirements, any one of these portable co*pressors addresses the airgunners ongoing need to keep their rifles supplied with air.